Difference between revisions of "Iomega Z100iDE ZIP"
Malvineous (Talk | contribs) (Add drive) |
Malvineous (Talk | contribs) (Not 250MB compatible after all) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 3: | Line 3: | ||
| Bus version = PIO-4 <!-- Might be UDMA? --> | | Bus version = PIO-4 <!-- Might be UDMA? --> | ||
| Manufacturer = Iomega | | Manufacturer = Iomega | ||
| − | | Compatible with = [[Has compatibility::ZIP100 | + | | Compatible with = [[Has compatibility::ZIP100]] |
| Connectors = None <!-- Not counting power or the interface connector above, nor jumpers or test points --> | | Connectors = None <!-- Not counting power or the interface connector above, nor jumpers or test points --> | ||
| Requires -5VDC = No | | Requires -5VDC = No | ||
| Line 34: | Line 34: | ||
Image:Iomega Z100iDE rear.jpg|Rear panel | Image:Iomega Z100iDE rear.jpg|Rear panel | ||
</gallery> | </gallery> | ||
| + | |||
| + | == Series == | ||
| + | |||
| + | There are other devices in this series from the same manufacturer. | ||
| + | |||
| + | {{#ask: | ||
| + | [[Category:Floppy drives]] | ||
| + | [[Manufacturer::Iomega]] | ||
| + | [[Has media type::Zip disk]] | ||
| + | | ?Bus type | ||
| + | | ?Bus version | ||
| + | | mainlabel = Device | ||
| + | }} | ||
Latest revision as of 10:40, 9 April 2016
| Bus type | IDE |
|---|---|
| Bus version | PIO-4 |
| Bus width | 16-bit |
| Bus speed | 8.33 MHz (16.66 MB/sec) |
| Manufacturer | Iomega |
| Chipset | Unknown |
| Compatible with | ZIP100 |
| Connectors | None |
| Requires -5VDC? | No |
| Requires -12VDC? | No |
| Floppy Drive | |
| Media type | Zip disk Property "Has media type" has been marked for restricted use. |
| Sides | 2 |
| Tracks | |
| Driver | N/A |
The Iomega Z100iDE ZIP is a native IDE (non-ATAPI) ZIP drive. It appears to the host machine as a hard drive, and does not require any drivers to run.
While not having to load any drivers may seem like a good idea, if the BIOS does not fully support removable IDE drives (e.g. some 486 PCs) then the machine may have to be rebooted after changing disks in order to see the contents of the new disk. Formatting disks may also have no effect.
Native IDE (non-ATAPI) Zip drives also cannot be booted as drive A: without BIOS support, and must be configured correctly otherwise they will appear to the system as drive C:.
It seems that these drawbacks were behind the reason for switching to the ATAPI protocol, so that the drives would be handled more like IDE CD-ROM drives, which have supported removable media since they were first introduced.
The native IDE versions of the drives seem to be most commonly associated with Dell computers, which presumably had the necessary BIOS support for these to work correctly as removable media devices.
Additional photos
Overhead
Rear panel
Series
There are other devices in this series from the same manufacturer.
