Difference between revisions of "Accton EN1650"
From Vogons Wiki
Malvineous (Talk | contribs) (Add driver URL) |
Malvineous (Talk | contribs) (Update infobox) |
||
| Line 1: | Line 1: | ||
| − | {{ | + | {{Device Infobox/Begin |
| Bus type = ISA | | Bus type = ISA | ||
| Bus width = 16-bit | | Bus width = 16-bit | ||
| Line 8: | Line 8: | ||
| Compatible with = [[Has compatibility::NE1000]], [[Has compatibility::NE2000]] | | Compatible with = [[Has compatibility::NE1000]], [[Has compatibility::NE2000]] | ||
| Connectors = [[Has connector::AUI]], [[Has connector::BNC]], [[Has connector::TP]] | | Connectors = [[Has connector::AUI]], [[Has connector::BNC]], [[Has connector::TP]] | ||
| + | | Requires -5VDC = No | ||
| + | | Requires -12VDC = No | ||
| + | | Config = [[Config method::Software]] | ||
| + | }} | ||
| + | {{Device Infobox/Ethernet | ||
| Is ROM socketed = Yes | | Is ROM socketed = Yes | ||
| ROM type = 28-pin JEDEC | | ROM type = 28-pin JEDEC | ||
| Is ROM writable = No | | Is ROM writable = No | ||
| − | + | }} | |
| − | + | {{Device Infobox/End | |
| − | + | ||
| Driver = [http://www.vogonsdrivers.com/getfile.php?fileid=901 Vogonsdrivers] | | Driver = [http://www.vogonsdrivers.com/getfile.php?fileid=901 Vogonsdrivers] | ||
}} | }} | ||
Latest revision as of 18:11, 13 February 2016
Accton EN1650
| Bus type | ISA |
|---|---|
| Bus width | 16-bit |
| Bus speed | 8 MHz |
| 8-bit ISA compatible? | |
| Manufacturer | Accton Technology Corporation |
| Chipset | EN5020 |
| Compatible with | NE1000, NE2000 |
| Connectors | AUI, BNC, TP |
| Requires -5VDC? | No |
| Requires -12VDC? | No |
| Config method | Software |
| Ethernet | |
| Boot ROM | Socket, 28-pin JEDEC, read-only |
| Driver | Vogonsdrivers |
The Accton EN1650 is a 10Mbps network card.
Additional photos
Underside
Config utility
Diagnostics
Config options
Boot ROM
This card's boot ROM socket will take a standard 28-pin ROM chip. It has also been successfully tested with a 32-pin ROM chip using an adapter[1]. XTIDE will run without any problem.
The card's DOS drivers come with a configuration program (1STEP.EXE) that can be used to enable the ROM socket (it is disabled by default) and set the base address, as well as adjust all the usual options like base address and IRQ.
Resources
- I/O address: 240, 280, 2C0, 300, 320, 340, 360.
- IRQ: 2, 3, 4, 5, 10, 11, 12, 15, Disabled.
- Boot ROM size: 16kB only.
- Boot ROM: C000, C400, C800, CC00, D000, D400 and D800, Disabled.
