Difference between revisions of "Template:Device Infobox/ST-506 Controller"
From Vogons Wiki
Malvineous (Talk | contribs) m (Fix capitalisation of device type) |
Malvineous (Talk | contribs) m (Undo revision 2626 by Malvineous (talk) - wrong capitalisation fix) |
||
| Line 4: | Line 4: | ||
}} | }} | ||
</noinclude> | </noinclude> | ||
| − | {{Device Infobox/Type | ST-506 Controller | ST-506 | + | {{Device Infobox/Type | ST-506 Controller | ST-506 (RLL/MFM) Controller}} |
<includeonly>{{#ifeq:{{{IsInfoboxPage|N}}} | N | [[Category:ST-506 controllers]] }}</includeonly> | <includeonly>{{#ifeq:{{{IsInfoboxPage|N}}} | N | [[Category:ST-506 controllers]] }}</includeonly> | ||
{{Device Infobox/Item | ST-506 buses | [[Number of ST-506 buses::{{{ST-506 buses|Unknown}}}]] }} | {{Device Infobox/Item | ST-506 buses | [[Number of ST-506 buses::{{{ST-506 buses|Unknown}}}]] }} | ||
Revision as of 23:14, 25 March 2016
Device Infobox/ST-506 Controller
There is no image of this device — upload one!
| Bus type | Unknown |
|---|---|
| Bus width | Unknown |
| Bus speed | Unknown |
| 8-bit ISA compatible? | Unknown |
| PCI 5V tolerant? | Unknown |
| PCI 3.3V tolerant? | |
| Manufacturer | Unknown |
| Chipset | Unknown |
| Connectors | Unknown |
| Requires -5VDC? | Unknown |
| Requires -12VDC? | Unknown |
| Config method | Unknown |
| ST-506 (RLL/MFM) Controller | |
| ST-506 buses | Unknown |
| ROM type | |
| Driver | Missing download URL |
This template is used to populate the Device Infobox with information about an ST-506 RLL/MFM controller card. See DTC 7287 for example use. As this template sits inside an infobox, it can be combined with other templates in the case of multi-function devices.
Valid parameters and examples specific to this infobox are:
| Parameter | Meaning |
|---|---|
| ST-506 buses = Value | Number of ST-506 (RLL/MFM) buses that are available on the device. Each bus typically supports the connection of up to two drives.
|
| ROM type = Value | Text value for the type of ROM/EEPROM/Flash chip. One of:
Add others to this list as needed - try to be as generic as possible, avoiding part names and using interface names instead. |
Default values are shown if the parameter is omitted, so do not use any parameters unless the value is known (most of the defaults say "unknown").
