Difference between revisions of "Serial port"
Malvineous (Talk | contribs) (Document two types of pinouts) |
(No difference)
|
Revision as of 19:23, 11 February 2017
Serial port is the term given to an RS-232 connector used to connect peripheral devices such as mice and modems to computers.
The serial port originally used a male DB25 connector (the same as used on parallel printer cables) however many of the signals were unused and later a smaller male DB9 connector was used instead.
PCB connectors
While many motherboards and add-in cards that provide serial ports have a DB9 connector on-board, many have a 10-pin (2x5 pin) IDC/Dupont connector for additional ports. A DB9 or DB25 connector can be plugged in to these and the socket mounted either in an add-in slot, or in DB9/DB25-sized holes on the back of many computer cases.
Unfortunately the pinout for these connectors was never standardised, and two major variants are in use. Devices rarely indicate which variant they use, even when supplied with a manual. Most devices shipped with the correct cables so it would seem the manufacturers thought this was unnecessary (despite often including pinouts for things like ISA slots), however as cables have been lost over the years it is usually a matter of trial and error to find the correct connector to use today.
In this article we will label the two variants as Type-A and Type-B.
Type-A
This connector uses a "straight through" arrangement. Pin 1 goes to pin 1, pin 2 goes to pin 2, and so on. Newer boards tend to use this arrangement (approximately since the Pentium 1 era).
Type-A top view, IDC pin 1 is red
Type-A bottom view, IDC pin 1 is red
Type-B
This version has the PCB connector mirror the physical arrangement of the DB9 pins, so the top row of the IDC pins match the top row of the DB9 pins. However when using pin numbering, this arrangement appears more complex:
| IDC pin | DB9 pin |
|---|---|
| 1 | 1 |
| 2 | 6 |
| 3 | 2 |
| 4 | 7 |
| 5 | 3 |
| 6 | 8 |
| 7 | 4 |
| 8 | 9 |
| 9 | 5 |
| 10 | N/C |
This style of wiring is much easier to manage when soldering to a DB25 connector, so this is most likely why it is used on earlier devices when DB25 serial ports were common. It is marginally easier to solder to a DB9 connector, but not by much.
Type-B top view, IDC pin 1 is red
Type-B bottom view, IDC pin 1 is red
