Socket 4 Motherboards
Socket 4 was released in 1993 and was used for the initial Pentium "P5" 60MHz and 66MHz processors. Intel also released two Pentium Overdrive CPUs based on "P54C", operating at 120MHz and 133MHz. There are no other CPU options for this socket without the use of VRM adapters such as Powerleap PL-54C/MMX. Intel quickly abandoned Socket 4 as the 5V Pentiums produced an excessive amount of heat. Usually Socket 4 motherboards have ISA and PCI slots, though most of the earlier models have VLB or even just ISA. Socket 4 motherboards typically use 72-pin SIMM FPM DRAM modules, but sometimes supported 30-pin memory as well. Most of the time 72-pin memory is fitted in pairs if the motherboard uses a 64-bit memory bus, however some of the earlier chipsets from OPTi were crude reworkings of their 486 chipsets that still used 32-bit data paths. These motherboards allowed SIMMs to be installed one at a time, but were best avoided due to their poor performance.
All Socket 4 motherboards were made as baby AT motherboards or in proprietary formfactors for OEMs.
Chipsets
- Intel 430LX "Mercury"
- SiS 501/502/503 PCI, ISA
- ALi M1449, M1451 "Aladdin" PCI, ISA
- Forex 601A/602A PCI, VLB, ISA (PCI appears to be bridged to VLB)
- OPTi 571/572 VLB, ISA (Hybrid 486/586 design, 32-bit SRAM, DRAM)
- OPTi 693/696 VLB, EISA (supports dual CPUs)
- OPTi 596/597 "Cobra / Premium" (CPU host interface, 32bit VLB, 64bit L2 cache, 64bit DRAM)
- OPTI 546/547 "Python" (fixes bugs in the Cobra chipset, PCI and VLB not bridged)
- OPTi 556/557/558 "Viper" (supports dual CPU)
Today: Socket 4 is an uncommon choice because the boards and CPUs were produced in quantities much smaller than their 3.3V cousins, and configuration options are extremely limited. The old chipsets used for it are also drawbacks.
