Template:Device Infobox/IDE Controller

From Vogons Wiki
Jump to: navigation, search
Device Infobox/IDE Controller
There is no image of this device — upload one!
Bus type Unknown
Bus width Unknown
Bus speed Unknown
8-bit ISA compatible? Unknown
PCI 5V tolerant? Unknown
PCI 3.3V tolerant?
Manufacturer Unknown
Chipset Unknown
Connectors Unknown
Requires -5VDC? Unknown
Requires -12VDC? Unknown
Config method Unknown
IDE Controller
IDE buses Unknown
Primary? Unknown
Secondary? Unknown
Tertiary? Unknown
Quaternary? Unknown
ROM type Unknown
Driver Missing download URL

This template is used to populate the Device Infobox with information about an IDE controller card. See AB-862G Super I∕O Card for example use. As this template sits inside an infobox, it can be combined with other templates in the case of multi-function devices.

Valid parameters and examples specific to this infobox are:

Parameter Meaning
IDE buses = Value Number of IDE buses that are available on the device. Each bus typically supports the connection of up to two drives.
  • 0 if none
  • 1 if only one bus (up to two drives)
  • 2 for a card with a primary and secondary bus (up to four drives), etc.
Primary = Value Boolean value indicating whether an IDE interface can be set as the first, or primary, IDE bus in the system. Typically this is at I/O address 0x1F0 and uses IRQ 14.
Secondary = Value Boolean value indicating whether an IDE interface can be set as the second, or secondary, IDE bus in the system. Typically this is at I/O address 0x170 and uses IRQ 15.
Tertiary = Value Boolean value indicating whether an IDE interface can be set as the third, or tertiary, IDE bus in the system. Often this is at I/O address 0x1E8 and uses IRQ 11 or 12.
Quaternary = Value Boolean value indicating whether an IDE interface can be set as the fourth, or quaternary, IDE bus in the system. Oten this is at I/O address 0x168 and uses IRQ 10 or 11.
ROM type = Value Text value for the type of ROM/EEPROM/Flash chip. One of:
  • None - no ROM chip is present
  • 28-pin JEDEC - standard byte-wide 28-pin ROM/PROM
  • 32-pin JEDEC - standard 32-pin EEPROM/flash chip
  • PLCC32 - 32-pin PLCC flash chip
  • TSOP40 - 40-pin TSOP package, usually flash memory

Add others to this list as needed - try to be as generic as possible, avoiding part names and using interface names instead.

Default values are shown if the parameter is omitted, so do not use any parameters unless the value is known (most of the defaults say "unknown").

Retrieved from "https://www.vogonswiki.com/index.php?title=Template:Device_Infobox/IDE_Controller&oldid=2303"